CLOCK HAND AND GEAR REMOVER 1/8" POST

Finely finished jaws (1/8") fit under clock hands and screw pressure raises hands from dial safely. Does not touch dial or rest of mechanism. Also used for pulling small gears. Jaw opening: 9/32"...

BOTTOM RESET EXTENSION STEM 10 1/4"

Bottom reset stem. Length: 101/4".  Includes rod, cotter pin, and knurled nut.  Nut must be fitted to rod (not threaded). Reset stem coupler 4.03mm (.159") I.D.  

HANSEN HAND SET ROD 10"

Hansen hand set rod. Length: 10".  Comes with coupler, brass end knob, and two cotter pins.

HAND REMOVER AND WHEEL PULLER

Quality built puller is perfect for pulling hands, gathering pallets and other items before dismantling a movement. Throat meastures a full 1" while the lower foot is only 1/16" thick.

HANSEN RESET STEM 10"

Hansen reset stem. Length: 10".  Includes cotter pin.

HAND BUSHING ADJUSTING TOOL

Steel shaft. Red wooden handle. Used for turning and adjusting square minute hand bushings. Length: 7".

CLOCK HAND AND GEAR REMOVER 1/16" POST

Finely finished jaws (1/16") fit under clock hands and screw pressure raises hands from dial safely. Does not touch dial or rest of mechanism. Also used for pulling small gears. Jaw opening: 9/32"